spacer
 
 

New Secure Large Carrier™

Return to previous page showing Secure Large Carrier™ products »

Run End Connector Left/Right

The Secure Large Carrier™ Run End Connector Left/Right with welded end cap is used to end a run of Secure Large Carrier™ Raceway. Two (2) manufactured mounting points allow simplified, labor-saving installation. The upper mounting point aligns with the mounting point on the end of adjoining raceway. Four (4) integrated one-inch spacers stand the connector and raceway off the wall. The Run End Connector also allows a transition to a 1″ Through-Wall Kit. Use the Run End Connector Left (SLC-CT-REC-LT) for raceway runs that end to the left. Use the Run End Connector Right (SLC-CT-REC-RT) for raceway runs that end to the right.

  • 16-gauge electro-galvanized steel
  • Two (2) manufactured mounting points
  • Four (4) integrated one-inch spacers allow 360° inspection
  • Packaged individually
  • Weight: 2.75 lbs
  • Powder Coat Finish: White Textured



0
 SLC-CT-REC-LT/RT Data Sheet

SLC Trim Plate

Through-Wall Trim Plate Kit

The Secure Large Carrier™ Through-Wall Trim Plate Kit covers the hole made when installing a section of Secure Large Carrier™ Raceway through a wall. The two-piece Trim Plate Kit covers the hole on both sides of the wall.

  • 16-gauge electro-galvanized steel
  • Weight 1.5 lbs
  • Packaged with two (2) trim plates per kit
  • Powder Coat Finish:  White Textured



0
SLC-TWK-TP Data Sheet

SMP Drop Connector

The Secure Large Carrier™ to Secure Mini Dukt™ Drop Connector provides the transition between Secure Large Carrier™ Raceway and Secure Mini Dukt™, usually leading to a User Drop Box. Installation requires two (2) Mounting Brackets (SLC-WM-MB), two (2) Secure Raceway Joints (SLC-RW-SRJ), and TopCap from the SLC Raceway Kit (SLC-WM-RCW-ST-20). Two (2) manufactured mounting points align with the Mounting Brackets allowing simplified, labor-saving installation and a one-inch standoff.

  • 16-gauge electro-galvanized steel on SLC component
  • 18-gauge electro-galvanized steel on SMD component
  • Two (2) manufactured mounting points 1.5” from each end
  •  Weight 2.5 lbs
  •  Powder Coat Finish:  White Textured

0 SLC-SMD-DP Data Sheet

INF Right

Retrofit Interface Sleeve

The Retrofit Interface Sleeve fits any secure enclosure with a depth of six (6) inches or greater and was designed for installation scenarios when the Secure Large Carrier Pull Box 0 (SLC-WM-PB0-H1) is too small for the amount of cabling. The Retrofit Interface Sleeve provides an exit for secure network cables from either the left or right side of the enclosure.

A paper installation template is supplied with the Retrofit Interface Sleeve ensuring accurate positioning on the enclosure. Additional copies of the template are available at:  http://holocom.com/pdfs/SLC-RTF-INF TEMPLATE-1 26 13.pdf

If using the downloaded version of the INSTALLATION TEMPLATE, be sure to verify that dimensions are to scale as photocopy machines may distort the imprint size.

  • 16-gauge electro-galvanized steel
  • Fits secure enclosures with a depth of six (6) inches or greater
  • Supplied with paper installation template
  • Packaged and sold individually for left or right
  • Weight: 1.5 lbs
  • Powder Coat Finish: White Textured



0 SLC-RTF-INF-LT and SLC-RTF-INF-RT Data Sheets